Finishing An Unfinished Attic

Finishing an attic turns the finished parts into standard living spaces making them subject to all of the same rules that apply to other living areas of the home.

Finishing an unfinished attic.

A contractor or a local building official can help you assess how the rule will apply to your attic and how modifications like dormers can resolve height shortcomings. Any living space requires at least 7 feet of headroom over a floor area of at least 70 square feet measuring at least 7 feet in each direction. Finishing your attic can add space and utility and increase the value of your home as long as it s done properly. Clean your unfinished attic repair it if necessary clean the attic out and inspect for any damages that will need to be fixed before starting your attic renovation check the insulation between the floor joists.

If your home is smaller than other homes in your area or simply lacks the necessary amount of storage or living space for your family finishing your attic is a relatively inexpensive way to increase your usable space. Follow the rule of 7s. At the lyons house this meant that only a portion of the attic was usable though some of the low clearance area was tapped for storage. In rare cases especially in new construction homes the attic may have been built unfinished with the correct flooring in place with the idea that the homeowner could later on finish the space.

Finishing the attic my preference is to push the knee walls close to the eaves creating as much floor space as possible. Low cabinets and bookcases fit snugly in the space under slanted ceilings. Replace any attic insulation where necessary. Use a nail gun to attach sheets of osb to the walls over the insulation.

Converting your attic into usable finished space can increase the value of your home by maximizing the available square footage. There are no special exceptions just because it s living space in the attic. To meet all three goals insulating your finished attic ventilating the roof and maximizing headroom use a combination of dense batt insulation rigid foam sheeting and air chutes. Here are some must do tips to follow when finishing your attic.

When done without proper planning or adherence to local building codes it can actually reduce the value of your home or stall a sale. Enforcement varies but codes typically say that at least half of a finished attic must be at least 7 feet high and that this area must be a minimum of 7 feet wide and 70 square feet. Make sure to nail into the wall studs when installing the osb image b. In most cases though the joists cannot support live loads and may not even be covered with boards.

Always wear safety glasses and use caution when working with a nail gun.