From the outside hook the tape measure over the outside wall corner and measure in 17 1 4 inches and you should find a stud.
Find wall stud under siding.
This is not always the case depending on the installer.
The better way is to locate the edges of the osb sheathing.
If i don t have any luck.
Locate the switches and outlets which indicate a stud.
Want to know the fastest easiest genius way to find a wall stud in your home or rv.
You should feel when it goes into the stud.
The best way to find a stud while working on on the outside whether brick siding or stone is to use an electronic stud finder.
Since the baseboard is attached to the studs look to see if.
If that s true and i wanted to hit a stud close to dead center i d probably make myself about a 6 long 3 32 diameter drill bit locate a stud from inside and bore a hole from inside out next to the stud.
Remove the section of siding at the elevation you plan on mounting the awning at.
Place the stud finder at the edge of the exterior siding.
Keeping these points in mind here are the ways i ve been most successful at finding studs.
If there are no gaps use a long thin nail and nail it about 1 2 from the edge of the box on each side into the wall.
Look at the trim for where it has been nailed to a stud.
The box is attached to a stud on one side.
To the best of my knowledge we won t see a stud by lifting siding unless the house was built about 1925.
Walk very slowly along the exterior siding while holding the stud finder.
The edges must be nailed into a stud.
Add another 1 2 inch for the boxing and 3 4 inch for standard lap siding.
In theory the siding should be nailed at the studs.
If you have gaps around the outlet box use a long nail or knife blade to locate the stud on either side of the box.
If you don t find signs of a stud 16 inches.
You will be wow d.
Measure 16 and mark additional stud locations.
Add the 5 1 4 inch thickness of the wall to the 12 inches.
Adjust wall thickness measurements accordingly for thicker walls.
If you have access to a magnetic stud finder begin this step by running the device across your wall of choice and wait for it to indicate the presence of a wall stud.